Preshared Key: (your passsword, same as you chose in IPSecuritas)Īdvanced: Aggressive mode is enabled and locked. Phase 1 DH Group: Group1, encryption DES, Authentication MD5, SA Lifetime 28800sec. Remote client is also Gateway Type Dynamic IP + E-mail Addr. Local security type also matches the client settings: Subnet 192.168.2.0 255.255.255.0 (USER FQDN) Authentication.Įmail address: user, matching the IPSecuritas setup on the Powerbook. Local Security Gateway Type is Dynamic IP + E-mail Addr. (This is with the latest firmware from July 2005, ver. On my RV042 router, I have Tunnel 1 enabled as a Client to Gateway on WAN1. Options: IpSec DOI, SIT_IDENTITY_ONLY, MIP6, Initial Contact, DHCP Pass-through, Establish IKE Immediately, Auto Start are all checked.Īlso, on the IPSecuritas Preferences menu, I have checked 'Replace DNS Settings on IPSec Activation' with our domain name and the internal IP address of our DNS, 192.168.2.134. Local Identifier: DN, (I don't think this needs to be a valid e-mail address as long as it is the same on both devices) Remote Network: 192.168.2.0/24 (this is the numbering system of the LAN behind my RV042) Remote IPSec Device: (note, this gives the "external" WAN IP address of my router, as hosted by DynDNS) IPSecuritas client settings are as follows:
Ipsecuritas will not save connection software#
The key piece of software is a program called IPSecuritas from This has the same function as VPN Client, but includes a lot more options and settings. Someone on the Apple support boards was having a similar problem.